6 magnets per sheet · photo face 50 × 76.2 mm
A blank verification sheet with your wraparound text in place — check the placement before using a real photo. Print at Actual Size / 100% (not Fit to Page) on plain paper, then run it through the press to confirm the cells seat and the ruler measures 1.00 cm. Doesn't use your quota.
Photo face: 50 × 76.2 mm
Default cell: 71.46 × 97.66 mm (photo face + 21.46 mm wraparound).
Cell size in millimetres
⚠ This default is formula-derived, not yet die-press validated — run a Test Print and die-test before a production order.
Cell width has only ~0.5 mm of headroom to the page-width max (71.96 mm) — room to narrow toward the face, not to widen.
Print preview · die-cut (flat sheet)
Die-cut octagon (the cell). Its diagonals touch the photo-face corners; text hugs the photo edge in the bands and wraps over to the back.
Octagon 71.46 × 97.66 mm · Photo 50 × 76.2 mm · Wraparound 11 pt
Back side · folded over (180° flip)
The finished magnet's back — each flap folds over the 50 mm plate edge, flipping the upside-down print text 180° so it reads right-side-up. Bare plate in the center.
Order number: 0001 — derived from the sheet position, never typed.
Positions run top→bottom, then the next column. Each photo is auto-cropped (subject-aware) to the 50 × 76.2 mm face. JPEG, PNG, and HEIC (iPhone) are supported.
0 of 6 positions filled on this sheet · PDF is generated in your browser — photos never leave your device.